Difference between revisions of "KF7CRU Tape Measure Yagi Antenna"
(Initial creation) |
m |
||
| Line 15: | Line 15: | ||
[[File:TapeMeasureYagiParts.jpg|600px]] | [[File:TapeMeasureYagiParts.jpg|600px]] | ||
| + | |||
[[File:TapeMeasureYagiCrossTapeSecureDetail.jpg|600px]] | [[File:TapeMeasureYagiCrossTapeSecureDetail.jpg|600px]] | ||
Revision as of 16:29, 3 September 2015
Tape Measure Yagi Antena
Resources
Antennas
- TAPE MEASURE BEAM OPTIMIZED FOR RADIO DIRECTION FINDING Joe Leggio WB2HOL
- ]https://sites.google.com/site/tapemeasureantenna/ https://sites.google.com/site/tapemeasureantenna/]
- VHF 3EL Tape Measure Yagi.
- Constructing a Tape Measure Yagi Antenna For Hidden Transmitter Hunting or Fox-Hunting
- Adapting a Three Element Tape Measure Beam for Power Line Noise Hunting
- BUILDING THE WB2HOL FOXHUNTING BEAM
Attenuators
- My Offset Attenuator Project
- Build An Offset Attenuator By Joe Moell KØOV
Build
I used a short length of pipe to secure the tape in the T. Beveled the edges a bit to make it easier to start.
I used a short length of pipe to secure the tape in the T
Is this a straight enough beam element? Or should I use hose clamps. Thinking about turning it in my lathe to remove the pipe stop ridges inside to create a clear path.
