KF7CRU Tape Measure Yagi Antenna

From Review or Discard at Will
Revision as of 16:28, 3 September 2015 by Jeffa (talk | contribs) (Initial creation)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

Tape Measure Yagi Antena

Resources

Antennas

Attenuators

Build

TapeMeasureYagiParts.jpg TapeMeasureYagiCrossTapeSecureDetail.jpg

I used a short length of pipe to secure the tape in the T. Beveled the edges a bit to make it easier to start.

TapeMeasureYagiCrossTapeSecureCloseDetail.jpg

I used a short length of pipe to secure the tape in the T

TapeMeasureYagiBeam.jpg

Is this a straight enough beam element? Or should I use hose clamps. Thinking about turning it in my lathe to remove the pipe stop ridges inside to create a clear path.